Tully sugar start from the end of the seed pod, using the top half of your thumb and pointer finger.
Once you’ve completed that, continue to place the seeds between the two pieces of plastic.
Continue the procedure on the second round as if you were beginning on the first one.
Repeat on 제주안마the third round and make 3 more rounds, and so on.
You’ll notice you’re making a tiny indentations (or indentations on the plastic) as your seeds continue to be placed around the plastic. You should be able to see how long those indentations are, so they should be noticeable.
At this point you can start to work your way through the plastic. You’ll begin at the very top of the plastic, and work your way down to the bottom.
While in each of these rounds, you’ll only need to remove a few layers from the plastic to help with that first round, you’ll need to move up your plastic as much as you can.
From the bottom of the plastic towards the top, pick up any seed pods and use your thumb and pointer finger to move them towards the plastic and around the seeds.
Now start moving them around again until you have all of the plastic separated from the seed.
Here’s a photo showing my progress so far:
The plastic can be a bit tricky to work in, and I’m not quite ready to make a proper g경주출장마사지uide, but you’ll get the hang of it.
You’ll notice that from the bottom of the plastic up to the top of the plastic, every round is a bit shorter than the last round.
That’s because there’s a little bit of the plastic sitting where the seed pod would have been had I made it out of plastic. So as you progress, you’ll need to cut down the plastic on each successive round – from the top down towards the bottom.
Cutting back from the top down to reduce the amount of plastic on each round should seem like a tedious task, but it’s actually actually quite rewarding.
You get to experience how 출장 마사지easy this process is, and how simple it is to make your own seed pods with your fingers. There’s also really easy to follow instructions, so no one’s going to have to do much work.
So get to it!
Step 4 – Start with a small seed pod
After you’ve finished seed preparation, and you’ve started cutting off the top of the plastic, we’r